Controls for platform lifts shall comply with 309.
Ada clear floor area latch approach.
Clear floor or ground space.
Additional stalls shall be provided in conformance with 4 22 4.
A slide side approach to a sliding or folding door requires a clear space in front of the door measuring a min.
Provisions for these elements apply the clear floor or ground specifications in 305.
There are many regulations and calculations that go into designing an ada ramp but the ramp landing size is commonly miscalculated because the door size door swing and ramp approach are often not considered.
Entry doors to acute care hospital bedrooms for in patients shall be exempted from the requirement for space at the latch side of the door see dimension x in figure below if the door is at least 44 in 1120 mm wide.
804 3 1 clear floor or ground space.
Requirement beside the door on the latch side and so the clear space box may slide left or right as necessary in front of the door in this scenario.
If the depth of a standard toilet stall is increased at least 3 in 75 mm then a floor mounted water closet may be used.
A clear floor or ground space complying with 305 positioned for parallel approach shall be provided.
If the latch side clearance is at least 42.
Space at least 60 deep in front of a door will accommodate a forward approach except in case of hinge approaches on the pull side.
Sufficient clear floor or ground space is required at accessible controls operable parts drinking fountains lavatories and sinks atms and fare machines appliances beds and other elements.
4 13 7 two doors in series.
410 3 clear floor space.
410 6 doors and gates.
The floor or ground area within the required clearances shall be level and clear.
Latch side clearance is required if the depth is 60 min.
All required door clear floor spaces to have a maximum slope of 1 48 2 per cbc.
611 2 clear floor space.
Ada sources 309 operable parts 404 2 manual doors doorways and manual gates 404 2 2 double leaf doors and gates.
A clear floor space complying with 305 positioned for a forward approach shall be provided.
The clearance between the platform sill and the edge of any runway landing shall be 1 1 4 inch 32 mm maximum.
Operable parts including doors lint screens and detergent and bleach compartments shall comply with 309.
Arrangements shown for standard toilet stalls may be reversed to allow either a left or right hand approach.
Any ramp system that is intended for public use must comply with the americans with disabilities act ada.
On the pull side of hinge approaches 36 min.
The depth can be 54 min.
Again this diagram does not have a min.
410 4 platform to runway clearance.
The clear floor or ground space shall be centered on the appliance.