Ada Pull Handle Requirements

Stationary knobs with a shape that can be loosely gripped also are acceptable.

Ada pull handle requirements.

Doors not requiring full user passage such as shallow closets may have the clear opening reduced to 20 in 510 mm minimum. A minimum of 10 inches is required from the bottom of pull handle to the finished floor on the corridor side. ü sliding or swing door hardware must not require more than 5 pounds of force to operate. For this reason a maximum opening force is not specified for exterior hinged doors.

Reach ranges for children are lower than 48. Handles pulls panic bars door hardware ada compliant locks exit devices handles pulls latches and other operable parts on doors shall comply operable parts of such hardware shall be 34 inches minimum and 48 inches maximum above the finish floor or ground. The minimum force needed to ensure proper closure and positive latch usually exceeds the accessible limit of 5 pounds of force lbf required at other doors. ü locking ladder pulls must have a lever actuator not a typical thumb turn requiring a push as well as turn rotation.

Section 404 of the ada states. ü the pull handle must be operable with one hand limb without tight grasping pinching or twisting of the wrist. Standard u shaped pulls and lever shaped handles are acceptable. Ada requirements state the pull or handle should be easy to open with one hand without twisting the wrist or using any tight grasping or pinching motion.

In general the requirements are a minimum of 32 in width and a maximum of 48 and the door must open to 90 degrees. Door openings shall provide a clear width of 32 inches 815 mm minimum. Clear width is 32 inches 815 mm minimum measured from the one side wall to the face of the opposite side wall. The maximum depth of the opening shown is 24 inches 810 mm.