Adjust Door Strike Plate

Then reinstall the plate with longer screws.

Adjust door strike plate.

Typically if you loosen both screws 1 2 full counterclockwise turns with your screwdriver or allen wrench the strike plate will be free to adjust. Screw the strike plate to the jamb then re bend the tab into the latch pocket by tapping it with a screwdriver and hammer. Open the door and look for a telltale kiss on the strike plate. Latches that don t fit properly into these plates will allow doors to rattle or prevent them from closing.

Adjust strike plates to close doors securely. Need to drill a new hole really close to the original one. 6 fill the gap between the strike plate and the door jamb with wood. Turn the latch to draw in the bolt close the door and turn the latch again so the bolt hits the strike plate.

To snug the door up you would move the strike plate toward the center of the door jamb. Unscrew the strike plate from the door jamb clamp it in a vise then file it down to the chalk mark above right. Reinstall the plate and test the dead bolt. Find a store near me.

Find strike plates at lowe s today. For minor adjustments you may be able to loosen the plate and tap it in the direction you need. For pricing and availability. Gatehouse steel entry door strike plate.

The stripped hole repair kit from king s original ha. If your filing action is shaking the strike plate remove the plate and secure it in a vise for your repair. Move it away from the center if the strike will not seat when the door is closed. The strike plate is the piece of door hardware that attaches to the door jamb and receives the latch.

Have a door out of alignment due to settling. If it only misses by 1 8 inch or less the problem can likely be solved by tapping the plate in the right direction with a hammer. Loosen the screws until the strike plate is free to move slightly. Insert either a triangular file or a flat file that s small enough to fit inside the strike plate.

Thankfully the door latches and knobs don t have to be moved to correct these problems. Skip to main content. Gatehouse steel entry door deadbolt strike plate. Use a screwdriver to loosen the screws slightly.